MITSUBISHI ELECTRIC LT-40133 - Manual (Page 77)

Appendices 77
Appendix E: Troubleshooting
Reset Name When to Use How to Use Resulting Action
Format When the picture shape
seems incorrect, use
FORMAT to change the
shape of the picture. Press the FORMAT key to cycle through the
available formats to find the best format
for the current picture.
The last-used format for a signal
type is memorized for each input.
The next time the same input and
the same signal type is viewed, the
last-used format will be recalled.
PerfectColor™
and PerfecTint™
Reset
(for the single
input currently
being watched) When the color intensities
seem out of balance,
use the PerfectColor/
PerfecTint reset to reset
the color balances to the
original factory settings.
Both PerfectColor and
PerfecTint and are reset
at the same time. 1. While viewing the input to be reset,
press MENU to display the Main
menu with the A/V icon highlighted.
2. Use to highlight PerfectColor
and press ENTER to display the
PerfectColor adjustment screen.
3. Press CANCEL to reset the colors.
All PerfectColor/PerfecTint sliders
are reset to the original center
position. The PefectColor/PerfecTint
settings for other inputs remain
unchanged.
Note: PerfecTint sliders are avail-
able only on model LT-40134.
A/V Memory
Reset
(for the single
input currently
being watched) When audio and/or video
settings for a single input
seem incorrect, use A/V
Memory Reset to return
the input to the original
factory settings. 1. While viewing the input to be reset,
press MENU to display the Main
menu with the A/V icon highlighted.
2. Use to highlight the Reset icon
and press ENTER to reset.
All Video and all Audio ( except
Balance, Listen To, & Language)
settings for an individual input
are reset. In addition, two global
settings (Video Noise & SharpEdge)
are reset to their original factory
settings.
A/V Reset
(for all inputs) To reset audio and
video adjustments for
ALL inputs back to their
original factory settings. While viewing the TV, press the side
panel buttons
GUIDE and FORMAT at the
same time.
All Audio and Video settings are
returned to their original factory
settings.
Channel
Memorization To erase and re-
memorize channels on
ANT 1 or ANT 2. 1. While viewing the TV, press MENU to
display the Main menu.
2. Press to highlight the Setup icon.
3. Press to highlight the Scan icon.
4. Press to highlight the antenna
input and reception mode, e.g.
ANT 1 Air.
5. Press to highlight the Start
button icon and press ENTER to start
the memorization.
All previously memorized channels
for the selected antenna input are
erased and a new set of memorized
channels is created. All custom
settings for Fav, channel names, and
channel locks are deleted. To add or
delete individual channels, see Edit
menu instructions in chapter 5, “TV
Menu Settings.”
Lock Menu Pass
Code To change your Lock
menu pass code
See the cutout page in Appendix B. Allows a new code to be
established.
TV Reset Comparison Guide
You can resolve many common TV problems using the
reset functions described in the following table. See
also the additional troubleshooting suggestions later in
this appendix.
IMPORTANT
Before you change sound or picture settings: If
picture or sound settings seem wrong for a broadcast
channel (a channel from ANT 1, ANT 2, a cable box, or
satellite receiver), first check other channels from the
same input before changing settings. If most other
channels from the same input seem correct, there is
likely a problem with the broadcast rather than with the
TV. Use care in this case, as changes you make to fix
problems on individual channels also affect all other
channels on the same input.