Interphase Tech CONDOR 4221 - Manual (Page 86)

Chapter 3 - MACSI Host Interface
74
Controller Initialization Block (CIB)
The CIB contains the actual values to use when initializing the controller. It may be located anywhere in Short I/O,
though it makes sense to place it after the MCE and before the Command Response Block.
Table 3-20. Controller Initialization Block
Number of CQE Entries
This field specifies the number of Command Queue entries to be used in the circular queue. Without using offboard
IOPBs, the maximum number ranges between 30 and 37. With offboard CQEs, this number can be increased to 151
(1812 / 12). Choosing the correct value is important to ensure maximum performance of the controller.
Controller Initialization Block
Offst 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0x00 Reserved Number of CQE Entries
0x01 Special Network Options
0x02 Reserved
0x03
to
0x05 Ethernet Physical Address (Port 0)
(6 Bytes)
0x06
to
0x08 Ethernet Physical Address (Port 1)
(6 Bytes)
0x09
to
0x0B Ethernet Physical Address (Port 2)
(6 Bytes)
0x0C
to
0x0E Ethernet Physical Address (Port 3)
(6 Bytes)
0x0F Controller Completion Level Controller Completion Vector
0x10 Controller Error Level Controller Error Vector
0x11 DMA Burst Count
0x12 Reserved
0x13 Offboard CRB Transfer Word
0x14 Offboard CRB Host Address (MSW)
0x15 Offboard CRB Host Address (LSW)