IronPort Systems 4108GL - Manual (Page 114)

6-12
Interface Access and System Information
System Information
In
te
rf
ace
Ac
cess
an
d
Syst
e
m
In
fo
rm
a
tio
n
Reconfigure the Age Interval for Learned MAC Addresses. This com-
mand corresponds to the MAC Age Interval in the menu interface, and is
expressed in seconds.
Syntax: mac-age-time <10 . . 1000000> (seconds)
For example, to configure the age interval to seven minutes:
HP4108(config)# mac-age-time 420
Configure the Time Zone and Daylight Time Rule. These commands:
■ Set the time zone you want to use
■ Define the daylight time rule for keeping the correct time when daylight-
saving-time shifts occur.
Syntax: time timezone <-720 . . 840>
time daylight-time-rule <none | alaska | continental-us-and-canada |
middle-europe-and-portugal | southern-hemisphere | western-europe |
user-defined>
For example, this command configures the time zone and daylight time rule
for Vancouver, British Columbia in Canada (time zone 8 = 480 minutes):
HP4108(config)# time timezone 480 daylight-time-rule
continental-us-and-canada
Configure the Time and Date. The switch uses the time command to con-
figure both the time of day and the date. Also, executing time without param-
eters lists the switch’s time of day and date. Note that the CLI uses a 24-hour
clock scheme; that is, hour (hh) values from 1 p.m. to midnight are input as
13 - 24, respectively.
Syntax: time [hh:mm[:ss]] [mm/dd/ [yy]yy]
For example, to set the switch to 9:45 a.m. on November 11, 2001:
HP4108(config)# time 9:45 11/11/01
N o t e Executing reload or boot resets the time and date to their default startup values.