IronPort Systems 4108GL - Manual (Page 374)

16-4
Spanning Tree Protocol (STP)
Menu: Configuring STP
S
pan
ni
ng Tr
ee P
rot
oc
ol
(ST
P
)
Menu: Configuring STP
1. From the Main Menu, select:
2. Switch Configuration . . .
4. Spanning Tree Operation
2. Press [E] (for Edit ) to highlight the Spanning Tree Enabled parameter.
3. Press the Space bar to select Yes . (Yes in this field means to enable STP.)
)
Figure 16-1. Example of the STP Configuration Screen
4. If the remaining STP parameter settings are adequate for your network,
go to step 8.
5. Use [Tab] or the arrow keys to select the next parameter you want to change,
then type in the new value or press the Space Bar to select a value. (If you
need information on STP parameters, press
[Enter] to select the Actions
line, then press H to get help.)
6. Repeat step 5 for each additional parameter you want to change.
Note: For information on the Mode parameter, see “STP Fast Mode” on
page 16-10.
Read-Only Fields
Use this field to enable or disable STP.