Copying event log output to a destination device, Copying crash data content to a destination device – IronPort Systems 4108GL User Manual
Page 459
A-17
File Transfers
Copying Diagnostic Data to a Remote Host, PC, or Unix Workstation
File
T
ra
n
sfe
rs
Copying Event Log Output to a Destination Device
This command uses TFTP or Xmodem to copy the Event Log content to a PC
or UNIX workstation on the network.
Syntax:
copy event-log tftp <ip-address> <filepath and filename>
copy event-log xmodem
For example, to copy the event log to a PC connected to the switch:
Figure A-8.
Example of Sending Event Log Content to a File on an Attached PC
Copying Crash Data Content to a Destination Device
This command uses TFTP or Xmodem to copy the Crash Data content to a PC
or UNIX workstation on the network. You can copy individual slot information
or the master switch information. If you do not specify either, the command
defaults to the master data.
Syntax:
copy crash-data [<slot-id | master>] xmodem
copy crash-data [<slot-id | master>] tftp <ip-address> <filename>
where:
slot-id = a - h, and retrieves the crash log or crash data from
the processor on the module in the specified slot.
master
Retrieves crash log or crash data from the switch’s
chassis processor.
For example, to copy the switch’s crash data to a file in a PC:
Figure A-9.
Example of Copying Switch Crash Data Content to a PC
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.
At this point, press
[Enter] and start the
Xmodem command
sequence in your
terminal emulator.