Integra CROMA24 - Manual (Page 100)

100 Assembly\Disassembly
Croma24 Service Manual
13. Once the Idler Pulley Assembly is in position, pinch the belt to
hold the Idler Pulley Assembly in place and pull it into the
Frame Tensioner so that the axle rests in the V-shaped groove
in the Frame Tensioner.
14. Insert the Compression Spring into the opening in the back of
the Frame Tensioner so that the end of the spring fits over the
post inside the opening.
15. Fit the Compression Spring over the post at the back of the C-
Bracket.
16. Fit the notch in the front end of the Frame Tensioner over the
notch in the front of the C-Bracket.
17. Depress the back of the Frame Tensioner and slip the Carrier
Belt over the Servo Motor pulley. Make sure that the guides in
the Carrier Belt are properly fitted over the Servo Motor
pulley.
18. Gently move the Carrier Assembly from end to end and make
sure that the Carrier Belt is not rubbing against any other
parts.
Remove the Carrier PCB
Integrated circuits may become weakened or damaged
by electrical discharge. Do not touch or work near
integrated circuits without wearing an ESD wrist strap.
1. Perform the Carrier Assembly, Carrier Belt, and the Frame
Tensioner Removal procedures to remove the Carrier Assembly
from the Slide Shaft.
2. Put on an ESD wrist strap.
3. Unlock the connectors and remove all flex cables on the Carrier
PCB. Ensure that the ferrite remains on the black cartridge
flex cable.