Integra CROMA24 - Manual (Page 111)

Assembly\Disassembly 111
ASSEMBL
Y/
DISASSEMBL
Y
Croma24 Service Manual
farther to the right might be required to release the left side
of the Service Station.
6. To remove a Service Station Wiper, lift the Wiper up and off
of the Wiper support.
7. To remove a Service Station Seal:
a. Disconnect the Sled spring from the post on the bottom of
the Service Station Sled. See Figure 5-13.
b. Slide the Service Station Sled to the right and up until it
is removed from the Service Station Base.
c. While pushing the Service Station Seal in, remove the
retaining ring from the other side. This releases the Seal Post
(with the Seal attached) and the Seal spring.
d. Remove the Seal from the Seal Post by sliding the rubber
Seal until it is released.
Install the Service Station, Seals, and Wipers
1. To install a Service Station Seal:
a. Slide the new Seal over the Seal Post.
b. Insert the Seal Post through the Seal spring.
c. Align the Seal Post and spring into the hole on the Service
Station Sled, it is keyed to only go in one way.
d. Press the Seal Post in to give enough clearance on the
other side to attach the retaining ring.
e. Insert the Service Station Sled into the Service Station
Base by sliding the Service Station Sled down and to the left
into the Base. To seat the Sled completely into the Base it
will be necessary to press down on the tab on the Actuator.
f. Reattach the spring onto the post on the bottom of the
Service Station Sled.
2. To install a Service Station Wiper, press the new Wiper onto
the wiper support.