Install the left, middle, and right covers – Integra CROMA24 User Manual
Page 89
Assembly\Disassembly
89
ASSEMBL
Y/
DISASSEMBL
Y
Croma24 Service Manual
Figure 5-1. Cover Removal/Installation.
5.
Remove the Left Cover by using a flat head screwdriver to
unhook the locking clasps located in Figure 5-1. All clasps but
one can be accessed from under the Base. The clasp located
near the AC input plug can be reached with a #1 flathead
screwdriver inserted into the slot between the Base and the
Cover above and to the left of the AC plug on the back of the
printer. See insert on Figure 5-1. Carefully lift off the Cover.
Install the Left, Middle, and Right Covers
1.
Align the locking mechanisms on the Left Cover with the holes
in the Base. Carefully push the Cover down onto the Base until
it locks into place.
2.
Align the locking mechanisms on the Right Cover with the holes
in the Base. Carefully push the Cover down onto the Base until
it locks into place.
3.
Reinsert the Middle Cover by pressing it back onto the left and
right pins. Lower the Middle Cover into the ready position.
4.
Reinstall the Cover Retaining Clips (2) into the square openings
in the Lid.