Integra DLV-100 - Manual (Page 22)

22
RGB
STATUS
POW
ER
ON
/ STAND BY
SOURCE
INPUT
3.OPERATION
AC IN
PC CARD
USB
VIDEO
S-VIDEO
RGB
AUDIO
PC CONTROL
M EN U
E N TER
CA
NC
EL
SELECT
AUTO ADJUST
PC CARD
ACCESS
STATUS
POWER
ON /
STAND BY
SOURCE
1
Connect the supplied power cable to the projector.
2 Turn on and off the Projector
3
Connecting the Power Cable and Turn on the Projector
POWER ON/STANDBY button
Indicator
To turn on the projector:
Only after you press the POWER (ON/STANDBY) button
on the projector cabinet or the remote control will the power
indicator turn to green and the projector become ready to use.
NOTE: To turn the projector on by plugging in the power cable, use
the menu and enable the “Auto Start” feature. (See page 37.)
NOTE: Immediately after turning on the projector, screen flicker may
occur. This is not a fault. Wait 3 to 5 minutes until the lamp lighting
is stabilized.
To turn off the projector:
First press the POWER (ON/STANDBY) button on the pro-
jector cabinet or the remote control. The power indicator will
glow orange. After the projector turns off, the cooling fans
keep operating for 90 seconds.
POWER ON/STANDBY button
Status of indicator light: turn on
INPUT
EN
T
ER
AUTO
ADJUST
PC
CARD
ACCESS
ON
/
ND BY
SOURCE
Select the Computer or Video Source
Adjust a Projected Image
Plug the supplied power cable in the wall outlet. The projec-
tor will go into its standby mode and the power indicator will
glow orange.
Before you turn on your projector, ensure that the computer or video
source is turned on and that your lens cap is removed.
POWER POWER
ON/STAND BY
POWER
Status of indicator light: turn off
ON
cooling down stand by
steady green light
change to flashing
green light steady orange light
Normal mode:
High-Bright mode:
POWER
STATUS
POWER
STATUS
ON/STAND BY
POWER
STATUS
stand by
steady orange light
flashing green light
for one minute. steady green light
POWER
STATUS
POWER
STATUS
ON/STAND BY
POWER
STATUS
stand by
steady orange light
flashing green light
for one minute.
(High-Bright mode) steady green light
(Normal mode)
NOTE: Do not disconnect the power cable during this time. Then, unplug the
power cable. The power indicator will go out.