Integra DLV-100 - Manual (Page 32)

32
Keystone distortion Normal
Aspect Ratio allows you to select the best Aspect mode to display
your source image.
When 4:3 is selected from the source (i.e. DVD player), the follow-
ing selections will display:
Normal Zoom Wide Zoom Cinema
Standard
4:3 Aspect
All 4 sides stretched Left & Right
stretched
Left and right
stretched
When 16:9 is selected from the source (i.e. DVD player),
the following selections will display:
Normal Zoom Wide Zoom Cinema
16:9 image displayed
in 4:3 mode
All 4 sides stretched Left & right stretched
Left and right
stretched to display
the true aspect
Keystone
This feature corrects the keystone (trapezoidal) distortion to make
the top of the screen longer or shorter to be the same as the bottom.
Use the
ᮤ or ᮣ buttons on the slide bar to correct the keystone
(trapezoidal) distortion.
NOTE: The keystone angle can be corrected between 30 degrees upward and
30 degrees downward at a 0 degree-projection angle.
Depending on the type of graphics being used, the picture may get
blurred or keystone correction may not be possible when excessive
keystone correction is used.
The idea is, the closer you are to native resolution, the better image
you will see.
Lamp Mode
Image Options
This feature enables you to select two the brightness modes of the
lamp: High-Bright and Normal modes. The lamp life can be extended
up to 1500 hours by using the Normal mode.
Normal Mode .............. This is the default setting.
High-Bright Mode ....... Select this mode to make the image brighten than
in Normal mode.
NOTE: If you have selected the Normal mode, the lamp lights in High-Bright
mode for one minute after the projector is turned on. After one minute the
lamp will change to Normal mode.
NOTE: You can select three image positions for Cinema: Top, center,
and bottom.
See page 35 for setting image positions.
Aspect Ratio (not available for RGB and PC Card Viewer)