Integra DLV-100 - Manual (Page 45)

45
5. TROUBLESHOOTING
This section helps you resolve problems you may encounter while setting up or using the projector.
Power/Status Light Messages
Standby
Cooling down
Lamp in Normal mode
Lamp in High-Bright mode
Retrying to turn on lamp
One minute after lamp is turned on
Lamp has reached its end of life
(High-Bright: 1000 hours or over)
(Normal: 1500 hours or over)
Lamp life has reached its end of
life
(High-Bright: 1100 hours or over)
(Normal: 1600 hours or over)
Lamp cover error
Temperature error
Fan error
Lamp error
Condition
Steady orange
Blinking green
Steady green
Steady green
Steady green
Blinking green
Steady green
Steady orange
Steady orange
Steady orange
Steady orange
Steady orange
–
–
–
Steady green
Blinking orange
No light in Normal mode / Steady green
in High-Bright mode
Steady red
Steady red
Blinking red (1 sec interval)
Blinking red (4 sec interval)
Blinking red (8 sec interval)
Blinking red (12 sec interval)
–
Blinks green for 90 seconds
–
–
The projector retries 3 times at an interval of 15
sec for max. 45 sec)
–
Message appears on screen during 1500-1600
hours (1000-1100 hours: High-Bright mode) of
lamp usage. The projector reaches its end of life.
Please replace the lamp as soon as possible
The projector is in standby mode and cannot be
turned on.
The projector is in standby mode and cannot be
turned on.
The projector is in standby mode and cannot be
turned on.
The projector is in standby mode and cannot be
turned on.
The projector is in standby mode and cannot be
turned on.
Power Indicator Status Indicator Note