Integra DLV-100 - Manual (Page 25)

25
If the projector cabined is used, each time the Source button is pressed,
the input source will change as follows:
→ RGB → Video → S-Video → PC Card Viewer 
If no input signal is present, the input will be skipped.
Basic Operation
Selecting the computer or video source
Optimizing RGB image automatically
Press the Auto Adjust button to optimize an RGB image automati-
cally.
Press the Auto Adjust button to fine-tune the computer image or to
remove any vertical banding that might appear and to reduce video
noise, dot interference or cross talk (this is evident when part of your
image appears to be shimmering). This function adjusts the clock
frequencies that eliminate the horizontal banding in the image. This
function also adjusts the clock phase to reduce video noise, dot inter-
ference or cross talk. (This is evident when part of your image ap-
pears to be shimmering.)
This adjustment may be necessary when you connect your computer
for the first time.
NOTE: The Auto Adjust function does not work for component signal.
Turning off picture and sound
Press the Mute button to turn off the image and sound for a short
period of time. Press again to restore the image and sound.
increase volume
decrease volume
Volume bar
Volume control
Sound level from the speaker on the projector can be adjusted.
NOTE: When the menu or the magnifying glass appears, you cannot adjust the
volume.