Cornelius ICE FROST User Manual
Page 13
Ice Frost Operator’s Manual
© 2004-2006, IMI Cornelius Inc.
- 9 -
Publication Number: M620919596OPR
P
ROGRAMMING
E
LECTRONIC
T
OUCH
P
AD
To Enter Time Programming on Initial Installation or in the Event of Service
1.
Turn the power switch OFF.
2.
Press and hold the left “PRESS TO SELECT FUNCTION” button and turn ON the power switch.
Release the “PRESS TO SELECT FUNCTION” button when the hour digits start blinking.
3.
Set the hour by pressing the “AUTO TIMER” clock button until the appropriate hour is shown.
NOTE: When using a 12 hour clock the time is P.M. when the dot at the bottom right corner of the
LED display is lit; A.M. when dot is not lit.
4.
Press the left “PRESS TO SELECT FUNCTION” button to set the minutes, then press the “AUTO
TIMER” clock button until the appropriate minutes are set.
5.
Press the “PRESS TO SELECT FUNCTION” button one more time to save your settings.
To lower the control cover, use a coin or other object to turn the keyless lock to the horizontal position, in
order to access the operating panel (controls are located on the right side of the unit).
Main Power Switch
• Turns unit ON.
• Selects 12/24 time clock or F
o
/C
o
tempera-
ture display when turned ON while simulta-
neously depressing the auger button.
• Sets current time when turned ON while
simultaneously depressing the “PRESS TO
SELECT FUNCTION” button.
Auger ON/OFF Button
• Turns auger ON and OFF when main
power switch is ON.
• Must be ON to permit COLD time to be
reset.
• Must be ON to activate the “PRESS TO
SELECT FUNCTION” button to select manual
“OFF”, “FREEZE”, or “COLD” functions.
PRESS TO SELECT FUNCTION Button
• Used to manually select “OFF”, FREEZE”,
or “COLD” functions when auger is turned
ON.
• Accesses COLD timer reset mode when
depressed for an extended period when
auger is turned ON.
• Locks in hours, minutes and final time set-
tings after they are reset using the “AUTO
TIMER” button.
• Does not function when light on “AUTO
TIMER” button is illuminated.
“AUTO TIMER” Button
• Turns auto COLD mode ON or OFF (light
on switch indicates when auto COLD mode is
activated).
• Used to adjust the hours and minutes set-
tings when readjusting current time or auto
COLD timer.
FIGURE 9