Cornelius ICE FROST - Manual (Page 6)

Ice Frost Operator’s Manual
Publication Number: M620919596OPR - 2 - © 2004-2006, IMI Cornelius Inc.
INSTALLATION
1. Remove the equipment from the packing, then slide it off
upwards (see FIGURE 1).
2. Checking the machine identification after removing the
packing, you must check that the equipment you have
received is exactly as you ordered, making sure the
specifications indicated on the invoice or the delivery note
are identical to those on the data plate.
FIGURE 1
3. Equipment accessories
The following accessories are included inside the bowls:
• This instruction manual;
• 1 tube of Vaseline to be used for the maintenance machine the requires;
• A drip tray.
The back-lit cover is packed separately from the machine.
4. Positioning - make sure the machine’s bodywork is well ventilated, at least 6”, and do not install
near heat sources.
We recommend you keep the room temperature at between 59 and 77°F.
IMPORTANT: All the pieces of packing must be kept out of reach of children as they represent
potential hazards.
5. Remove gear motor shipping pins and tags from the rear of the unit prior to installation.
C
ONNECTING THE
E
LECTRICITY
M
AINS
Before inserting the plug into the mains socket for your own
safety you must take careful note of the following precautions.
• The machine’s electrical system can only be considered safe
when it is connected correctly to a grounded outlet, as
provided for by the national safety regulations. The
manufacturer cannot be held responsible for any damages
that may be caused by failure to earth the system.
• For the system to be installed correctly and safely, it is
essential to provide a suitable socket having a dedicated 20
Amp circuit which complies with the national safety
standards in force (see FIGURE 2).
FIGURE 2
• Check the power supply cable to make sure it is not being crushed, do not use extension cords and, to
remove the plug, first turn OFF the switch, then hold the plug tightly and pull gently.
• Do not obstruct the ventilation and the heat dissipation grids as bad airing, in addition to reducing the
output and causing bad functioning, could also lead to serious damage to the equipment.
IMPORTANT: If the power supply cord is damaged, it must be replaced by qualified persons only
to prevent any possible risks.