Cornelius ICE FROST - Manual (Page 15)

Ice Frost Operator’s Manual
© 2004-2006, IMI Cornelius Inc. - 11 - Publication Number: M620919596OPR
Viewing the Bowl Temperature
1. Turn ON the auger on the side that you want to display the bowl temperature (press the “AGER ON/
OFF” button).
2. Press the “PRESS TO SELECT FUNCTION” button until the “Cold” LED is lit. The display will now
show the current bowl temperature in either
o
F or
o
C as applicable.
C
ONSISTENCY
A
DJUSTMENT
1. To dispense the product, place the cup beneath the
dispensing valve (Q) and pull the lever (R) very gently
(FIGURE 10).
2. Adjusting the viscosity:
To vary the viscosity of the product, turn the knob (S) as
shown in FIGURE 11.
Turning the knob counter-clockwise will increase viscosity
(make the product denser).
Turning the knob clockwise will decrease viscosity (make the
product less dense).
FIGURE 10
ATTENTION: This control only changes the viscosity of the
product dispensed, it does not effect the COLD
temperature.
ATTENTION: When the level of the product inside the bowl
is below the minimum level, you must switch the COLD
system (OFF position), or refill the bowl, following the
instructions given in the previous paragraphs.
An indicator gauge for reference is located on the back of the
unit approximately 6 inches below the adjustment knob.
NOTE: This indicator can not be viewed on all models.
FIGURE 11