InFocus MaxFlight MT3000(B) - Manual (Page 23)

MaxFlight Corporation
750 Airport Road ◦ Lakewood, NJ 08701
Phone: (732) 942-9898 Fax: (732) 942-1114
Electric MT3000 Daily Inspection Checklist
Date of Inspection: AM Inspected By:
PM Inspected By:
* These sheets must be filled out completely and kept in your records.
AM Check PM Check
Inspect projector for proper operation and cleanliness
Make sure that the ductwork is secure and functioning properly
Check to see canopy sensor works properly
Make sure the sound system and speakers are secure and operational
Make sure the cockpit Occupant Panic Switch is functioning properly
Inspect harnesses for proper operation and condition
Inspect seat belts for proper operation and condition
Make sure gas spring safety clips are secured properly
Make sure the screen assembly and padding are secure and in good condition
Make sure canopy alignment pins are tight
Inspect the Cockpit latch for proper operation and condition
Check stairway for any movement
_____ _____ Ensure the Emergency Stop Button is functioning properly
Make sure the tail boom stand is in good condition and its proper
location
Make sure the concealment panel on the tail cover is secure
Ensure that the molding on the cockpit and tail boom cover is intact and secure
Make sure tail cover bolts are snug
Inspect all fiberglass for any visible damage
Make sure all pine tree fasteners are in place and panels are secure
Check for general ride cleanliness
Inspect any entrances, exits, stairways, ramps, fencing, guarding and barricades
Inspect the flange welds of the Right/Left Pitch Shafts and Counterweight shaft
at the center weldment to ensure that there are no cracks, also inspect the safety
wire and bolts for security
Ensure the Manual Leveling and Lowering Brake release Levers are functioning
properly
NOTE: When inspection is completed, run one full ride cycle to ensure all system components function
properly