InFocus MaxFlight MT3000(B) - Manual (Page 86)

MaxFlight Corporation
750 Airport Road ◦ Lakewood, NJ 08701
Phone: (732) 942-9898 Fax: (732) 942-1114
MT3000 Weekly Inspection Checklist
Week Ending:
Inspected By (print):
Signature:
* These sheets must be filled out completely, kept in your records
and faxed to MaxFlight (Attn: Tech. Support) on a weekly basis.
Inspect the Roll ERC (Electrical Rotary Contact) and pins for proper
security and condition
Clean the projector fans and lens (DO NOT USE LIQUID CLEANER)
Inspect all connections on the Power Distribution Box for security
Inspect the Pitch ERC and Torque Arm for proper security and condition
Inspect the counterweight shaft, worm gear and guide rail for any apparent
wear, damage, or binding
Inspect left and right key-way bolts (both A-Frames) for security
Inspect the Up/Down, Canopy and Failsafe Sensors for security and proper
operation
Inspect the A-Frames for signs of “walking” if unit is not secured to floor
Inspect Harness for any weld cracks
Inspect safety-wired and visible bolts for security
Ensure the Daily AM and PM inspections have been complied with for the
past week(See Operators Manual)
Lubricate the unit in accordance with the Lubrication Diagram(page 26 of
Technical Manual)
Check the security of all Encoders, ensure the set screws are tight.
GAME LOG READING
Normal:
Hours:
Annotate any discrepancies from previous week and corrective actions
_______________________________________________________
_______________________________________________________
_______________________________________________________
___________________________________________________
_______________________________________________________
_________________