InFocus MaxFlight MT3000(B) - Manual (Page 44)

Parameter Description Pitch Roll Lift Weight
7 Acceleration time 1.0 0.1 0.1 1.0
8 Deceleration time 1.0 0.1 0.1 1.0
9 Electric thermal O?L relay 13.1/6.5 8.5/4.2 8.5/4.3 0.7
10 DC injection brake operation 4 1 1 3
12 DC injection brake voltage 4.0 3.0 3.0 3.0
15 Jog frequency 10.00 10.00 10.00 60.00
16 Jog acceleration/deceleration time .5 .5 5 0.1
22 Stall prevention level 175 175 175 0
29 Acceleration/deceleration pattern 1 0 0 0
30 Regenerative function selection 1 1 1 0
60 Intelligent mode selection 0 0 0 0
70 Special regenerative brake duty 30.00 30.00 30.00
71 Applied motor 13 13 13 3
72 PWM frequency selection 11 11 11 15
73 0-5V/0-10V selection 14 14 14
77 Parameter write disable selection 2 2 2 2
79 Operation mode selection 1* 1* 1* 1*
80 Motor capacity 3.7 3.7 2.2 0.1
81 Number of motor poles 4 4 2
82 Motor exciting current***
83 Rated motor voltage 230.0 230.0 208.0 208.0
84 Rated motor frequency 60 60 60 60
90 Motor constant (R1)***
91 Motor constant (R2)***
92 Motor constant (l1)***
93 Motor constant (L2***
96 Auto tuning setting 3 3 3 1
117 Station number 0 1 2 3
121 Number of communication retries 9999 9999 9999 9999
122 Communication check time
interval
9999 9999 9999 9999
145 PU language select 1 1 1 1
190 RUN terminal function selection 0* 0* 0* 0*
192 ABC terminal function selection
195 ABC terminal function selection 99 99 99
244 Cooling fan operation selection 1 1 1 1
903 Frequency setting voltage gain 120.0 120.0 120.0 60.0
Changed 4 Oct. 00
* Parameters 79 and 190 are adjusted during operation by the MFMotion software and may vary
after the unit has been operated once after initial configuration. It is usually not necessary to reset
these values again.
*** Parameters 82, 90, 91, 92, and 93 are configured during auto-tuning and are only visible and
updatable while parameter 77 is set to 801. They can be configured directly instead of auto-
tuning the inverter. If an inverter was auto-tuned, the values may vary from those shown.