InFocus MaxFlight MT3000(B) - Manual (Page 79)

5-20 Setup and Calibration of Joysticks and CIB-1000 Interface
5-20A Maxzilla Joystick Setup
Utilizing the new Maxzilla program and Motion Com the following are the setting requirements to get the
unit running in normal or demo mode.
Click on Configuration/Status Icon
The window that opened –Double click on Device Manager Icon
Click on or create CIB-1000 on COM#2
Enable ---CIB-1000 – Double click on it and when other page opens click on device tabto open
window. It should state enabled and Started, if not click on icon in front of it to cycle setting until
it is Enabled and Started. Say –OK
Click on or create Maxflight I/O System and enable it the same as CIB-1000
Double click on User Joystick this opens input page
Select:
+Maxzilla
+Maxzilla
2 nd
+Player
Go to Input Devices page tab and ensure that ;
CIB-1000 Control on Com#2
Maxflight I/O system----- are there and enabled
Go to Axes
Select:
Maxzilla
Steering CIB-1000, #0 , digital unchecked----Calibrate before use
Maxzilla 2
Select:
Steering, CIB-1000, #1, digital unchecked---- Calibrate before use
Go to Sliders
Select:
Maxzilla
Gas, CIB-1000, #2, digital unchecked --- Calibrate before use
Brake, CIB-1000, check digital, #1
Maxzilla 2
Gas, CIB-1000, #3, digital unchecked, ------Calibrate before use
Brake, CIB-1000, check digital, #0
Go to Buttons
Reverse, CIB-1000, check digital, #16
Maxzilla
Select 1, CIB-1000, digital, #5
Select 2, CIB-1000, digital #4