IBM System Storage Subsystem DS5020 - Manual (Page 209)

Appendix D. Power cords
For your safety, IBM provides a power cord with a grounded attachment plug to use
with this IBM product. To avoid electrical shock, always use the power cord and
plug with a properly grounded outlet.
IBM power cords used in the United States and Canada are listed by Underwriter’s
Laboratories (UL) and certified by the Canadian Standards Association (CSA).
For units intended to be operated at 115 volts: Use a UL-listed and CSA-certified
cord set consisting of a minimum 18 AWG, Type SVT or SJT, three-conductor cord,
a maximum of 15 feet in length and a parallel blade, grounding-type attachment
plug rated 15 amperes, 125 volts.
For units intended to be operated at 230 volts (U.S. use): Use a UL-listed and
CSA-certified cord set consisting of a minimum 18 AWG, Type SVT or SJT,
three-conductor cord, a maximum of 15 feet in length and a tandem blade,
grounding-type attachment plug rated 15 amperes, 250 volts.
For units intended to be operated at 230 volts (outside the U.S.): Use a cord set
with a grounding-type attachment plug. The cord set should have the applicable
safety approvals for the country in which the equipment will be installed.
IBM power cords for a specific country or region are usually available only in that
country or region.
Table 25. IBM power cords
IBM power cord
part number Feature
code
Description
Used in these countries or
regions
39Y7931 9800 Power Cord (125v,
10A, 4.3m) Antigua and Barbuda, Aruba,
Bahamas, Barbados, Belize,
Bermuda, Bolivia, Cayman Islands,
Costa Rica, Columbia, Cuba,
Dominican Republic, Ecuador, El
Salvador, Guam, Guatemala, Haiti,
Honduras, Jamaica, Mexico,
Micronesia (Federal States of),
Netherlands Antilles, Nicaragua,
Panama, Peru, Philippines, Saudi
Arabia, Thailand, Turks and Caicos
Islands, United States, Venezuela
© Copyright IBM Corp. 2009 179