Cornelius SID650A/80 - Manual (Page 17)

14 91704
6. Move the water float valve reservoir to the “Clean”position by lifting slightly and pulling forward to raise the
reservoir to the upper mounting screws.
7. Remove the float valve cover and add 4 ounces of Virginia Ice Machine Cleaner to the reservoir.
CAUTION: Virginia Ice Machine Cleaner is a mild acid, therefore normal care should be
taken when using. Keep out of eyes and cuts. Read warnings on package before using. Do
not operate unit in the cleaning mode without the ice drop cover in place. There may be
some overflow of cleaning solution through the evaporator vent tube during the cleaning cycle.
8. Open the water supply valve and fill evaporator with water (level is up in float reservoir).
9. Put the “Clean/Run”switch in the “clean”position. Allow unit to run in the cleaning mode for at least 30
minutes.
10. Put the “Clean/Run”switch in the “run”position.
11. Close the water supply valve.
12. Depress the “Flush”switch push button and drain evaporator for about 1-1/2 minutes. Release push but-
ton. Open the water supply valve. Allow evaporator to refill with water. Repeat Steps 11 and 12 three (3)
times to thoroughly remove cleaning solution from evaporator.
13. Close the water supply valve. Depress the “Flush”switch push button for 1-1/2 minutes to drain the evapo-
rator.
14. Lower the float valve reservoir to “Run”position. Remove the evaporator plug.
15. Open the water supply valve and fill the evaporator with water.
16. Put the “Stop/Run”switch in the “run”position and allow unit to run through at least three (3) complete ice
making cycles or until ice is free of “sweet”taste.
WARNING: If unit fails to harvest ice, put the “Stop/Run” switch in the “stop” position.
Close the water supply valve. Depress the “Flush” switch push button for 1-1/2 minutes to
drain the evaporator. Flush the evaporator with hot water to thoroughly melt all the ice in
the evaporator. Repeat Step 12 to remove all traces of the cleaning solution from the evaporator.
17. Dispense all ice out of storage hopper and discard.
Dispenser Section
1. Turn off the main electrical power supply to thr machine.
2. Remove the agitator assembly from storage hopper and wash and rinse it thoroughly.
3. Wash down all inside surfaces of the ice storage area, including the top cover and ice drop cover with a
mild detergent solution and rinse thoroughly to remove all traces of detergent.
4. Replace the agitator.
5. Remove ice chute cover as follows:
A. Flex sides outward to disengage lower pins.
B. Lift ice chute cover to disengage upper pins.
C. Lower Ice Chute cover down out of unit. Note: It may be helpful to twist cover slightly.
6. Clean the inside of the ice chute, and ice chute cover with a mild detergent solution and rinse thoroughly to
remove all traces of detergent.