IBM 6341 User Manual
Page 10
DID YOU RECEIVE THE CORRECT RESPONSE?
If NO, continue to
002 .
If YES, proceed to
003 .
002
If the Power Management feature is enabled, do the following:
1.
Start the Configuration/Setup Utility program (see “Setup Utility program” on
page 10)
2.
Select Power Management from the Configuration/Setup Utility program
menu.
3.
Select APM.
4.
Be sure APM BIOS Mode is set to Disabled. If it is not, press Left Arrow (
}) or
Right Arrow (Æ) to change the setting.
5.
Select Automatic Hardware Power Management.
6.
Set Automatic Hardware Power Management to Disabled.
7.
If the problem persists, continue to
003 .
003
Run the Diagnostic programs. If necessary, refer to “Diagnostics” on page 12.
v If you receive an error, replace the part that the diagnostic program calls out or
go to
″Symptom-to-FRU Index″ on page 69.
v If the test stops and you cannot continue, replace the last device tested.
2
Hardware Maintenance Manual