IBM 6341 User Manual
Page 87
Diagnostic Error Code
FRU/Action
014-001-XXX
Parallel port Presence
1.
Remove external parallel device, if
present
2.
Run setup, enable port
3.
System board
014-002-XXX
014-003-XXX
Parallel port Timeout/Parity error
1.
System board
014-013-XXX
014-014-XXX
Parallel port Control Signal/Loopback test
failure
1.
System board
014-015-XXX
Parallel port External Loopback failure
1.
Wrap plug
2.
System board
014-027-XXX
Parallel port Configuration/Setup error
1.
Run Setup, enable port
2.
Flash the system
3.
System board
014-03X-XXX
014-04X-XXX
Parallel port failure
1.
System board
014-195-XXX
Parallel port Test aborted by user
1.
Information
2.
Re-start the test, if necessary
014-196-XXX
Parallel port test halt, error threshold
exceeded
1.
Press F3 to review the log file
2.
Re-start the test to reset the log file
014-197-XXX
Parallel port test warning
1.
Make sure the component that is called
out is connected and/or enabled
2.
Re-run test
3.
Component that is called out in warning
statement
4.
Component under test
014-198-XXX
Parallel port test aborted
1.
If a component is called out, make sure
it is connected and/or enabled
2.
Flash the system and re-test
3.
Go to the
″Undetermined problems″
section
014-199-XXX
Parallel port test failed, cause unknown
1.
Go to the
″Undetermined problems″
section
2.
Flash the system and re-test
3.
Replace component under function test
014-2XX-XXX
014-3XX-XXX
Parallel port failure
1.
External parallel device
2.
System board
015-000-XXX
USB port Interface Test Passed
1.
No action
015-001-XXX
USB port Presence
1.
Remove USB device(s) and re-test
2.
System board
Chapter 6. Symptom-to-FRU Index
79