Intel PXA255 - Manual (Page 568)

16-26 Intel® PXA255 Processor Developer’s Manual
Network SSP Serial Port
Bits that cause an interrupt signal the request as long as the bit is set. The interrupt clears when the
bits clear. Read and write bits are called status bits (status bits are referred to as sticky and once set
by hardware, they must be cleared by software); Read-only bits are called flags. Writing a 1 to a
status bit clears it; writing a 0 has no effect. Read-only flags are set and cleared by hardware; writes
have no effect. The reset state of read-write bits is zero and all bits return to their reset state when
SSCR0[SSE] is cleared. Additionally, some bits that cause interrupts have corresponding mask bits
in the control registers and are indicated in the section headings that follow.
Set the desired values for this register before enabling the SSP (via SSCR0[SSE]).
These are read/write registers. Ignore reads from reserved bits. Write zeros to reserved bits.
Table 16-8. SSSR Bit Definitions (Sheet 1 of 3)
0x4140_0008 SSSR Network SSP Serial Port
Bit 31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
reserved
BC
E
CSS TU
R
re
s
e
rv
e
d
TIN
T
re
s
e
rv
e
d
RF
L
TFL RO
R
RF
S
TFS BSY RN
E
TN
F
re
s
e
rv
e
d
Reset ? ? ? ? ? ? ? ? 0 0 0 ? 0 ? ? ? 1 1 1 1 0 0 0 0 0 0 0 0 0 1 ? ?
Bits Name Description
31:24 — reserved
23 BCE
BIT COUNT ERROR:
Indicates that the SSP has detected the SSPSFRM signal asserted at an incorrect time. This bit
will cause an interrupt if SSCR1[BCE] is set. The SSP will ignore the current sample and the
next sample in order to re-synchronize with the master.
Write one to clear this bit.
0 – SSPSFRM has not been asserted out of synchronization.
1 – SSPSFRM has been asserted out of synchronization.
22 CSS
CLOCK SYNCHRONIZATION STATUS:
A read-only bit that indicates the SSP is busy synchronizing the control signals. This bit is only
valid when the SSP is a slave to frame.
Software must wait until this bit is a 0 before allowing an external device to assert the SSPSFRM
signal.
0 – The SSP is ready for slave operations.
1 – The SSP is busy synchronizing slave mode signals.
21 TUR
TRANSMIT FIFO UNDER RUN:
Indicates that the transmitter tried to send data from the transmit FIFO when the transmit FIFO
was empty. When set, an interrupt is generated to the CPU that cannot be locally masked by any
SSP register bit. Setting TUR does not generate any DMA service request. To clear TUR,
software sets it. TUR remains set until cleared by software writing a one to it which also reset its
Interrupt request. Writing a zero to this bit does not affect TUR.
TUR can be set only when the port is a slave to the FRAME signal (SSCR1[SFRMDIR] set) and
is not set if the port is in receive-without-transmit mode (SSCR1[RWOT] set).
Write one to clear this bit.
0 – Transmit FIFO has not experienced an under run
1 – Attempted read from the transmit FIFO when the FIFO was empty, request interrupt.
20 — reserved