Intel PXA255 - Manual (Page 68)

3-6 Intel® PXA255 Processor Developer’s Manual
Clocks and Power Manager
keep each unit’s clock frequency within the unit’s clock tolerance. If a crystal other than
3.6864 MHz is used, the clock frequencies to the peripheral blocks’ interfaces may not yield the
desired baud rates (or other protocol’s rate)
3.3.6 Clock Gating
The Clocks Manager contains the CKEN register. This register contains configuration bits that can
disable the clocks to individual units. The configuration bits are used when a module is not being
used. After Hardware Reset, any module that is not being used must have its clock disabled. If a
module is temporarily quiescent but does not have clock gating functionality, the CKEN register
can be used to disable the unit’s clock.
When a module’s clock is disabled, the registers in that module are still readable and writable. The
AC97 is an exception and is completely inaccessible if the clock is disabled.
3.4 Resets and Power Modes
The Clocks and Power Manager Unit determines the processor’s Resets, Power Sequences and
Power Modes. Each behaves differently during operation and has specific entry and exit sequences.
The resets and power modes are:
• Hardware Reset
• Watchdog Reset
• GPIO Reset
• Run Mode
• Turbo Mode
• Idle Mode
• Frequency Change Sequence
• Sleep Mode
3.4.1 Hardware Reset
To invoke the Hardware Reset and reset all units in the processor to a known state, assert the
nRESET pin. Hardware Reset is only intended to be used for power up and complete resets.
Table 3-3. 147.46 MHz Peripheral PLL Output Frequencies for 3.6864 MHz Crystal
Unit Name Nominal Frequency Actual Frequency
UARTs 14.746 MHz 14.746 MHz
AC97 12.288 MHz 12.288 MHz
I 2 S 146.76 MHz 147.46 MHz