Gvrp and ingress filter settings, Description – Intel NetStructure 470 User Manual
Page 103
97
Using Local Management
C
H
A
P
T
E
R
5
Local Management
LOCATION
Main Menu
Configure a VLAN
GVRP/Ingress Filter Settings
NOTE
For GVRP to work, the port must
be connected to another port that
supports GVRP.
GVRP and Ingress Filter Settings
Description
Configure Ports: Identifies the range of ports that you can configure (press
z).
GVRP: Allows the switch to create VLANs dynamically. Press
z to
toggle the action for each port. Options are:
<Enabled>: The switch monitors traffic on this port for GVRP requests
from network nodes. If a GVRP-enabled device sends a request to this
port, the switch creates a VLAN dynamically and adds the requesting
device to the new VLAN. This is the default setting.
<Disabled>: The switch ignores GVRP requests in incoming packets
on this port.
Ingress Filtering: Allows the switch to filter incoming packets based on
VLAN membership. Use
z to toggle the action for each port.
Options are:
<Enabled>: Incoming packets belonging to a specific VLAN are
forwarded only if the port belongs to that VLAN. This is the default
setting.
<Disabled>: All packets coming into the port are forwarded, regardless
of the port’s VLAN membership.