Icom IC-R1500 - Manual (Page 21)

16
5
MEMORY OPERATION
4
5
■
General description
The receiver has 1100 memory channels including 100 scan
edge memory channels (50 pairs) for storage of often-used
frequencies. And a total of 21 memory banks, A to H, J to R,
T, U, W and Y are available for storing groups of frequencies,
etc. Up to 100 channels can be assigned to a bank.
D D Memory channel contents
The following information can be programmed into memory
channels:
• Operating frequency (p. 9)
• Receive mode (p. 10)
• Duplex direction (DUP+ or DUP–) with an offset fre-
quency (p. 15)
• Tone squelch or DTCS squelch ON/OFF (p. 33)
• Tone squelch frequency or DTCS code with polarity
(p. 38)
• Scan skip information (p. 28)
■
Memory channel selection
q Push [MR•SKIP] to select memory mode.
• “ ! ” indicator appears.
w Rotate [DIAL] to select the desired memory channel.
• Programmed memory channels can only be selected.
[MR•SKIP] “ ! ” appears
If memory banks or weather channels* mode appears at
step
q , push [MR•SKIP] and rotate [DIAL] to select “bAnk
--,” then push [MR• SKIP] again to return to channel selec-
tion.
*Available for USA/CANADA versions only.