Icom IC-R1500 - Manual (Page 7)

2
1
CONNECTION
1
D D OPC-1156 connection
q Connect the controller plug to the OPC-1156 jack.
w Detach the ferrite core from the controller cable, then at-
tach it to the OPC-1156 as shown below.
• Make sure to wind the cable on the ferrite core.
e Connect the OPC-1156 plug to the [CONTROLLER] con-
nector of the receiver.
■
Antenna installation
D Antenna location
To obtain maximum performance from the receiver, select a
high-quality antenna and mount it in a good location. It is not
necessary to use radials on a magnetic mount (“mag mount”)
antenna.
Receiver
OPC-1156
Controller
Jack
Ferrite core