JVC KD-AVX33 - Manual (Page 114)

34
ENGLISH
7
Operate the target Bluetooth device. (While
“Open...” is flashing on the screen.)
Enter the same PIN code (as entered in the above
step) on the device to be connected.
Now connection is established and you can use the
device through the unit.
The device remains registered even after you
disconnect the device. Use <Connect> (or activate
<Auto Connect>) to connect the same device
from next time. (☞ pages 58 and 59)
Searching for available devices
Perform steps 1 to 3 on the left, then...
1
The unit searches for available devices and displays
the list of them. (If no available device is detected,
“Device Unfound” appears.)
2
Select a device you want to connect.
3
Enter the specific PIN code of the device to
the unit.
• Refer to the instructions supplied with the device
to check the PIN code.
4
Use the Bluetooth device to connect.
Now connection is established and you can use the
device through the unit.
AV Menu
Bluetooth Enter ENT
AV Menu
Setup Enter ENT
Registering using <Open>
1
Select “Bluetooth Phone” or “Bluetooth
Audio.”
2
3
Bluetooth menu icon
4
5
Enter a PIN (Personal Identification
Number)* code to the unit.
• You can enter any number you like (1-digit to
16-digit number).
* Some devices have their own PIN code. Enter the
specified PIN code to the unit.
• To delete an unwanted digit, select blank space.
6
NEW DEVICE
Dial Menu
Message
Open
Search
Special Device
NEW DEVICE
Dial Menu
Message
Open
Search
Special Device
PIN Code
1234
Enter ENT
15: 45
FLAT
NEW DEVICE
Bluetooth Phone
Select “NEW DEVICE” by pressing
5 / ∞.
KD-AVX33[E]_0130.indb 34 KD-AVX33[E]_0130.indb 34 07.2.1 4:44:22 PM 07.2.1 4:44:22 PM