JVC KD-AVX33 - Manual (Page 382)

Connecting the external amplifiers
You can connect amplifiers to upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit.
• For amplifier only:
– After you have connected the center speaker, make sure to activate the center speaker; otherwise, no sound comes out of the connected center speaker, see page 49 of the INSTRUCTIONS.
– Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused.
– You can switch off the built-in amplifier and send the audio signals only to the external amplifier(s) to get clear sounds and to prevent internal heat buildup. See page 51 of the INSTRUCTIONS (separate
volume).
* 6 Audio cord (not supplied)
* 7 Firmly attach the ground wire to the metallic
body or to the chassis of the car—to the place
uncoated with paint (if coated with paint,
remove the paint before attaching the wire).
Failure to do so may cause damage to the unit.
Connecting external components
C
4
Center speaker
• iPod is a trademark of Apple Inc.,
registered in the U.S. and other
countries.
USB cable—
approx.1.2 m
B
USB device
Audio cord (not supplied)
3.5 mm stereo mini plug
External component
Remote lead
Remote lead (Blue with white stripe)
To the remote lead of other equipment
Y-connector (not supplied for this unit)
JVC Amplifier
JVC Amplifier
JVC Amplifier
JVC Amplifier
Rear speakers
Front speakers
Subwoofer
You can connect external components in series as shown in the diagram below.
• All the components, adapters or signal cords need to be purchased separately.
CAUTION:
Before connecting the external components, make sure that the unit is turned off.
• To use JVC CD changer, Apple iPod or JVC D. player, set “External Input” to “Changer/iPod/D.
Player” (see page 50 of the INSTRUCTIONS).
• To use other external components via KS-U57 or KS-U58, set “External Input” to “External
Input” (see page 50 of the INSTRUCTIONS)
External component KS-U57 * 8
KS-U58 * 9
KS-PD100
KS-PD500
Apple iPod
JVC D. player
Front speakers
JVC CD changer
or
CD changer jack
Hold the connector top tightly (1),
then pull it out (2).
To disconnect the connector
or
or
or
External component
External
component
External
component
or
CD changer jack
USB devices
* 8 Line Input Adapter KS-U57 (separately purchased)
* 9 Aux Input Adapter KS-U58 (separately purchased)
You cannot connect a computer to the USB ( ) terminal of the unit.
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
TROUBLESHOOTING
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
• Unit becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• This unit does not work at all.
* Have you reset your unit?
Instal3-4_KD-AVX33[A].indd 5 Instal3-4_KD-AVX33[A].indd 5 07.2.21 11:06:08 AM 07.2.21 11:06:08 AM