JVC KD-AVX33 - Manual (Page 380)

2
When using the optional stay When installing the unit without using the sleeve
In a car having the “Required space for installation” (see page 1), first remove the car radio and install the
unit in its place.
Screw (option)
Stay (option)
Fire wall
Dashboard
Bracket * 2
* 2 Not included for this unit.
Flat type screws—M5 x 8 mm * 2
Bracket * 2
Install the unit at an angle of less than 30˚.
Note: When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws.
If longer screws are used, they could damage the unit.
Removing the unit
Before removing the unit, release the rear section.
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
30˚
Flat type screws—M5 x 8 mm * 2
Connecting the Mic unit
or
Adjust the microphone angle
Microphone
Microphone clip
J
Double-sided adhesive tape
C
Secure the microphone cord using cord cramps (not supplied) if necessary.
1 2
Connect the parking brake lead to the parking brake system built in the car.
Parking brake lead (light green)
To metallic body or chassis of the car
Parking brake switch (inside the car)
Parking brake
Connecting the parking brake lead
A
Connecting the reverse gear signal lead (for rear view camera) (REVERSE GEAR SIGNAL)
Locate the reverse lamp lead in the trunk.
To reverse lamp
Reverse lamp lead
Reverse lamp lead
To car battery
Purple with white stripe
Reverse lamps
B
Instal1-2_KD-AVX33[A].indd 2 Instal1-2_KD-AVX33[A].indd 2 07.2.21 11:04:50 AM 07.2.21 11:04:50 AM