Jotul GF 100 DV II - Manual (Page 24)

24
GF 100 DV II Nordic QT
GF 200 DV II Lillehammer
MANUAL
AUTO
OFF
BLOWER
Optional Blower # 155631
Installation
1. Unpack and check the con-
tents of the blower kit. Con-
tact your dealer if any damage
is evident or parts are missing.
See fig. 35.
2. Attach the Control Box to the
Snapstat Bracket using two
#8 x 1/2” sheet metal screws.
As shown in fig. 35, use the
pair of mounting holes appro-
priate for your stove.
3. Attach the Control Box to the
studs located underneath the
stove in the middle of the
firebox floor using the two M6
hex nuts and a 10 mm socket
driver or wrench. See fig. 36.
CONNECT THE GAS SUPPLY TO THE
STOVE BEFORE INSTALLING THIS
BLOWER. USE A 90° ELBOW OFF THE
GAS VALVE TO CREATE ADEQUATE
GAS LINE CLEARANCE.
„ „ „ „ „ THIS BLOWER MUST BE
ELECTRICALLY GROUNDED IN
ACCORDANCE WITH LOCAL CODES
OR, IN THE ABSENCE OF LOCAL
CODES, WITH THE CURRENT ANSI/
NFPA 70, NATIONAL ELECTRICAL
CODE OR CSA C22.1-CANADIAN
ELECTRICAL CODE.
„ „ „ „ „ THIS UNIT IS SUPPLIED WITH A
THREE-PRONG (GROUNDING) PLUG
FOR PROTECTION AGAINST SHOCK
HAZARD AND SHOULD BE PLUGGED
DIRECTLY INTO A PROPERLY
GROUNDED THREE-PRONG
RECEPTACLE. DO NOT CUT OR
REMOVE THE GROUNDING PRONG
FROM THE PLUG.
„ „ „ „ „ ALWAYS DISCONNECT THE POWER
SUPPLY WHEN PERFORMING ANY
SERVICE ON THE FIREPLACE INSERT.
Contents
1. Blower
2. Snapstat Wire Harness
3. Control Box
4. Snapstat Bracket
5. Rheostat Knob
6. Snapstat
7. Mounting Bracket (GF100 DV II ONLY)
8. M6 Flange Nuts, (2)
9. M6 x 12 Hex Bolts, (2)
10. #8 x 1/2” Sheet metal screw, (4) Tools Required
• 1/4” socket driver
• 10 mm socket
driver or wrench
Figure 36. Attach Control Switch Box.
Secure with
two Hex Head
Flange Nuts
Snapstat
Figure 35. Blower Kit Components
1
2
6
7
10
9
8 5 3
4
Upper Holes
for GF100
DV II
Lower Holes
for GF200
DV II
10
10