Juniper Networks J-series Services Router J2320 - Manual (Page 204)

Figure 82: Alternative Horizontal Orientation of J4350 and J6350 Compact Flash
To replace the compact flash:
1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to the ESD point on the chassis, or to an outside ESD point if
the router is disconnected from earth ground. For more information about ESD,
see “Preventing Electrostatic Discharge Damage” on page 251.
3. Press and release the power button to power off the router. Wait for the POWER
LED to turn off.
4. Remove the power cord or cable from the power source receptacle.
5. Remove the screws from the sides and top of the chassis that secure the cover
to the chassis.
6. Slide the cover off the chassis.
WARNING: If the fans are still rotating, wait until they stop before proceeding with
the next step, especially if your compact flash is in the horizontal position (flat against
the system board).
7. Slide the compact flash out of its slot, as shown in Figure 83 on page 183.
182 ■ Replacing Internal Compact Flashes on J4350 and J6350 Routers
J2320, J2350, J4350, and J6350 Services Router Getting Started Guide