Tim516 analog telephony interface module – Juniper Networks J-series Services Router J2320 User Manual
Page 98
Table 41: TIM514 Possible Port Configurations
Possible Analog Trunk (TRUNK) Port Configurations
Possible Analog Telephone (LINE) Port
Configurations
Loop-start or ground-start central office trunk with a loop current of 18
milliamperes (mA) to 120 mA
Wink-start or immediate-start DID trunk
Two-wire analog outgoing centralized automatic message accounting
(CAMA) emergency E911 trunk, for connectivity to the PSTN
Multifrequency (MF) signaling is supported for CAMA ports.
Analog tip/ring devices such as single-line telephones
with or without LED message-waiting indication
The TIM514 also provides the following features:
■
Three ringer loads, the ringer equivalency number for up to 2,000 ft (610 m),
for all eight ports
■
Up to four simultaneously ringing ports
■
Type 1 caller ID and Type 2 caller ID
■
Ring voltage generation for a variety of international frequencies and cadences
For pinouts of cable connectors for the TIM514, see “TIM514 Connector
Pinout” on page 242.
To install or remove an Avaya VoIP module, see “Replacing a PIM” on page 172.
TIM514 LEDs indicate link status and activity. Table 42 on page 76 describes the
meaning of the LEDs.
Table 42: LEDs for TIM514
Description
State
Color
Label
Alarm. A TIM514 failure requires
monitoring or maintenance.
On steadily
Red
ALM
Active. A device connected to the
TIM514 is in use. This situation can
include a telephone that is off the
hook.
Blinking
Yellow
ACT
For more information about the TIM514, see the Avaya manual Hardware Description
and Reference for Avaya Communication Manager.
TIM516 Analog Telephony Interface Module
The TIM516 Analog Telephony Interface Module (Figure 45 on page 77), also known
as the TIM516 analog media module, has 16 analog telephone lines.
76
■
Avaya VoIP Modules
J2320, J2350, J4350, and J6350 Services Router Getting Started Guide