Juniper Networks J-series Services Router J2320 - Manual (Page 309)

United States
The Services Router has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference
in which case the user will be required to correct the interference at his own expense.
FCC Part 15 Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged
to try and correct the interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and the receiver.
■ Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
■ Consult the dealer or an experienced radio or TV technician for help.
FCC Part 68 Statement
This equipment complies with Part 68 of the Federal Communications Commission
(FCC) rules. On the product is a label that contains the FCC registration number for
this device. If requested, this information must be provided to the telephone company.
This equipment is designed to be connected to the telephone network or premises
wiring using a compatible modular jack which is Part 68 compliant. See installation
instructions for details.
If this device causes harm to the telephone network, the telephone company will
notify you in advance that temporary discontinuance of service may be required.
The telephone company may request that you disconnect the equipment until the
problem is resolved. The telephone company may make changes in its facilities,
equipment, operations or procedures that could affect the operation of this equipment.
If this happens, the telephone company will provide advance notice in order for you
to make necessary modifications to maintain uninterrupted service.
Compliance Statements for EMC Requirements ■ 287
Chapter 14: Safety and Regulatory Compliance Information