Juniper Networks J-series Services Router J2320 - Manual (Page 260)

Table 90: RJ-48 Connector to DB-15 Connector (Crossover) Pinout (continued)
Signal
DB-15 Pin
(Data Numbering
Form)
RJ-48 Pin (on T1/E1 PIM)
(Data Numbering Form)
No connect No connect 7
No connect No connect 8
No connect No connect 9
No connect No connect 10
No connect No connect 11
No connect No connect 12
No connect No connect 13
No connect No connect 14
No connect No connect 15
E3 and T3 BNC Connector Pinout
The E3 and T3 PIMs each use two BNC connectors—one for transmitting data ( TX )
and one for receiving data ( RX ).
ADSL and G.SHDSL RJ-11 Connector Pinout
The 1-port ADSL 2/2+ Annex A and Annex B PIMs use an RJ-11 cable, which is not
supplied with the PIMs. The 2-port G.SHDSL Annex A and Annex B PIM also uses an
RJ-11 cable, which is not supplied with the PIM. Table 91 on page 238 describes the
RJ-11 connector pinout.
Table 91: ADSL and G.SHDSL RJ-11 Connector Pinout
Signal Pin
No connect 1
No connect 2
RJ P –Tip 3
RJ N –Ring 4
No connect 5
No connect 6
238 ■ E3 and T3 BNC Connector Pinout
J2320, J2350, J4350, and J6350 Services Router Getting Started Guide