JVC DR-MV1B - Manual (Page 49)

Masterpage:Right+
EN
49
Filename [DR-MV1SEK_06DVD Operation2.fm]
Page 49 April 15, 2004 3:30 pm
OPERATIONS ON DVD DECK
Check, Cancel And Change Programmes
1
When the DVD timer lamp lights on the unit
Press DVD TIMER (#), then press 1.
When “ ” lights on the front display panel and the DVD
timer lamp also lights up on the unit.
Press 1.
When “SAT#” lights on the front display panel
Press SAT# on the unit, then press 1.
When the DVD lamp does not light up on the unit
Press VCR/DVD repeatedly so that the DVD lamp lights up on the
unit.
2
Press PROG/CHECK to
access the Programme Check
screen.
● To return to the previous screen
after you check the programme,
press PROG/CHECK again.
To cancel the programme
Press rt to select a programme
to be cancelled, then press
CANCEL (&).
3
Press rt to select the programme, then press ENTER. The
programme screen appears.
4
Change the settings of the desired recording options as
required.
● Refer to steps 5 – 10 in “Manual Timer Programming” ( ੬ pg. 46).
5
Press PROG/CHECK to complete timer correction. The
previous screen resumes.
6
For VIDEO Plus+, Manual or On-Disc Timer Programming
Press DVD TIMER (#).
For Automatic Satellite Programme Recording
Press SAT# on the unit for 2 seconds or more.
● The DVD timer lamp also lights up on the unit and the VCR deck is
automatically selected. When the VCR deck is in timer standby
mode, the unit is automatically turned off.
When Programmes Overlap Each Other
If “PROGRAM OVERLAPPED” appears, you have another
programme overlapping the programme you have just made.
Confirm with the arrow on “OK”, then press PROG/CHECK.
Programme Check screen appears and conflicting programmes
will be highlighted in pink.
Example: Programme 3 (you
have just made) and
Programme 4 overlap each
other.
1
Confirm the overlapping
programmes. Overlapping
programmes appear on the TV
screen.
NOTE:
If you do not mind this overlap, press PROG/CHECK to finish the timer
programme setting. The programme with the lower programme number
will be recorded and the other one will not be recorded correctly. If no
changes are made for approximately 1 minute, the unit will return to the
normal screen.
2
Press rt to select the desired programme to be cancelled or
changed.
To cancel the programme
Press CANCEL (&).
● “THE TIMER PROGRAMING SETTING WAS CANCELLED” appears
on the TV screen for about 5 seconds, then the normal screen
resumes.
To change the programme setting
Press ENTER, then go to step 3.
3
Change the programme setting.
● Refer to steps 5 – 10 in “Manual Timer Programming” ( ੬ pg. 46).
4
Press PROG/CHECK to check if the conflict has been settled.
Programme check screen appears.
5
Engage the unit’s timer mode.
● Refer to step 6 in “Check, Cancel And Change Programmes”
( ੬ pg. 49).
NOTE:
When any overlaps remain after deletion and modification of
programmes, Programme Check screen remains showing the
conflicting programmes. In such a case, repeat the procedure above
until the conflict is solved.
1
4
7
2
5
8
0
3
6
9
PROG/CHECK
ENTER
CANCEL (&)
1
DVD TIMER (#)
rtw e
VCR/DVD
SAT
DR-MV1SEK_00.book Page 49 Thursday, April 15, 2004 3:30 PM