JVC DR-MV1B - Manual (Page 72)

Filename [DR-MV1SEK_09Editing.fm]
Masterpage:Left+
72
EN
Page 72 April 15, 2004 3:18 pm
EDITING
You can use a camcorder as the source player and your unit as the
recording deck.
1
Make connections.
A If the camcorder has no S-VIDEO output connector:
— connect the camcorder’s AUDIO/VIDEO OUT connectors to the
unit’s AUDIO/VIDEO input connectors on the front panel.
● When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your unit.
B If the camcorder has an S-VIDEO output connector: (DVD deck
only)
— connect the camcorder’s AUDIO OUT and S-VIDEO OUT
connectors to the unit’s AUDIO and S-VIDEO input connectors on
the front panel.
2
Press VCR/DVD repeatedly to select the recording deck.
3
Press PR +/– to select “F-1”.
For DVD deck
● Set “F-1 INPUT” to “VIDEO” for the VIDEO input connector, or
“S-VIDEO” for the S-VIDEO input connector, depending on the
connector being used. (
੬ pg. 75)
4
Press REC MODE repeatedly to set the recording mode.
5
Start playback on the camcorder slightly before the actual point
from where you wish to start dubbing.
6
Press 7 on the unit to start recording. Or press and hold 7 and
press 4 on the remote control. The dubbing starts.
7
Press 8 on the unit, then stop playback on the camcorder.
NOTES:
● All necessary cables can be obtained from your dealer.
● Refer to the camcorder’s instruction manual for operating procedure.
● The quality of dubbed picture becomes poorer than that of the
original.
Edit From A Camcorder
VPS/PDC VCD
HDD DVD
DV HS
BS +
STANDBY/ON
DVD
S-VIDEO VIDEO (MONO) L - AUDIO - R
VCR/DVD VCR
REMAIN
REC MODE SLOW << >>
PR DV IN SAT
DVD
DVD DVD VCR DUB
F-1
A If the camcorder has no S-VIDEO output connector:
Recorder
AUDIO/VIDEO OUT
Player
Audio/video cable
(not provided)
AUDIO/VIDEO input
VPS/PDC VCD
HDD DVD
DV HS
BS +
STANDBY/ON
DVD
S-VIDEO VIDEO (MONO) L - AUDIO - R
VCR/DVD VCR
REMAIN
REC MODE SLOW << >>
PR DV IN SAT
DVD
DVD DVD VCR DUB
F-1
B If the camcorder has an S-VIDEO output connector (DVD
deck only):
Recorder
Audio cable (not provided)
S-VIDEO OUT
AUDIO OUT
Player
AUDIO input
S-Video cable
(not provided)
S-VIDEO input
Slide the TV/CABLE/SAT/DVD switch to DVD.
DR-MV1SEK_00.book Page 72 Thursday, April 15, 2004 3:30 PM