Built-in dts, Mode) disc, Pg. 79) in th – JVC DR-MV1B User Manual

Page 79

Advertising
background image

Masterpage:Right+

EN

79

Filename [DR-MV1SEK_09Editing.fm]

Page 79

April 15, 2004 3:18 pm

SYSTEM CONNECTIONS

These instructions enable you to connect your unit to a Dolby
Digital decoder or an amplifier with built-in DTS.

1

Connect the unit and a Dolby Digital decoder or an amplifier

with built-in DTS using either an optional optical cable or an
optional coaxial cable.

NOTES:

● For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY

DIGITAL/PCM”. (

੬ pg. 80)

● For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”.

(

੬ pg. 80)

CAUTIONS:

● This unit has a dynamic range of more than 110 dB with regards to its

Hi-Fi audio capability. It is recommended that you check the
maximum level if you are going to listen to the Hi-Fi audio signals
through a stereo amplifier. A sudden surge in the input level to the
speakers may damage them.

● Some speakers and televisions are specially shielded to prevent

television interference. If both are of the non-shielded type, do not
place the speakers adjacent to the TV set as this can adversely affect
the playback picture.

When you can’t switch the audio channel of a bilingual
programme
When the unit is connected with a digital audio device using an
optional optical cable and “DIGITAL AUDIO OUT” is set to “DOLBY
DIGITAL/PCM”, it is not possible to switch the audio channel of a
bilingual programme recorded on a DVD-RAM or DVD-RW (VR
mode) disc. In this case, perform the following steps using the
remote control to switch “DIGITAL AUDIO OUT” from “DOLBY
DIGITAL/PCM” to “PCM ONLY”.
A Press SET UP to access the Main Menu screen.
B Press w e to select “DVD SET UP”, then press ENTER.
C Press w e to select “AUDIO OUTPUT”, then press ENTER.
D Press rt to select “DIGITAL AUDIO OUT”, then press
ENTER.
E Press rt to select “PCM ONLY”, then press ENTER.
(

੬ pg. 80)

F Press SET UP to complete the setting.
G Press AUDIO to select the desired audio channel. (੬ pg. 30)

Connecting To A Dolby Digital Decoder
Or An Amplifier With Built-in DTS

2

Note for connection:
Remove the protection cap from the cable.

Coaxial cable

(not provided)

Dolby Digital Decoder or

amplifier with built-in DTS

To DIGITAL AUDIO input

Optical cable
(not provided)

DIGITAL AUDIO OUT (OPTICAL)

DIGITAL AUDIO OUT (COAXIAL)

DR-MV1SEK_00.book Page 79 Thursday, April 15, 2004 3:30 PM

Advertising