JVC LPT0976-001B - Manual (Page 37)

Masterpage:Right0
EN
37
Filename [MX1SEU_07HDD Operation.fm]
Page 37 Monday, 6 December 2004 14:01
BASIC OPERATIONS ON HDD DECK
1
Press VHS/HDD/DVD SELECT on the unit repeatedly or HDD
on the remote so that the HDD lamp lights up on the unit.
2
Press PR +/– or the number keys to select the channel you
wish to record.
3
Press REC MODE repeatedly to select the recording mode,
then press ENTER.
● Each time you press REC MODE, the recording mode changes
as follows:
XP N SP N LP NEP N FR60-FR360* N FR420, FR480 N
(Back to the beginning)
* The value is selectable from 1 to 6 hours in 5 minutes interval by
pressing D E repeatedly after selecting AFR60-FR360B. To change the
value in 30 minutes interval, press and hold D E .
● For details on the recording mode, see the right column.
4
Press R on the unit to start recording. Or while holding R, press
I on the remote control.
● The HDD recording lamp lights up on the unit.
5
Press o twice to stop recording.
● Pressing o once displays the confirmation message to stop
recording. Press o again to terminate recording.
NOTES:
● Continuous recording for over 48 hours is not possible.
● It is not possible to record on both DVD and HDD simultaneously.
Pause recording on HDD deck
It is not possible to pause recording. Pressing
W initiates Live
Memory Playback.
However, it is still possible to pause recording only when recording
the channels of external sources (
AL-1B, AL-2B, AF-1B, and ADVB).
While holding R, press W on the remote. To resume recording,
while holding R, press I on the remote.
No operation can be made with the buttons on the unit.
Recording Mode
MPEG2 format is used as recording format. As a guide for picture
quality, the
AbpsB unit is used to represent how much data can be
recorded per second. The larger this value is, the better the picture
quality becomes but more capacity is required for the recording.
Select XP or SP for programmes where quick movement occurs,
such as sports programmes, and LP or EP for talk shows, etc. with
relatively less movement.
● For details on FR mode, refer to AFree Rate FunctionB (A pg. 36).
NOTE:
The maximum recording time stated in the above table are the
approximate time under unused condition.
Basic Recording
● Turn on the unit.
● Turn on the TV and select the AV mode.
● Slide the TV/CABLE/SAT/DVD switch to DVD.
ATTENTION:
The HDD on the unit requires approximately 20 seconds to start
up after the unit has been turned on, during which no operation
can be made.
7 PR +/ 8
VHS/HDD/DVD
SELECT
4
7
8
0-9
REC MODE
HDD
PR+/-
9
CABLE/SAT
DVD TV
HDD lamp
Recording mode Maximum recording time (approx.)
XP 34 hours
SP 69 hours
LP 138 hours
EP 209 hours
FR480 300 hours
MX1SEU_00.book Page 37 Monday, December 6, 2004 2:01 PM