JVC LPT0976-001B - Manual (Page 56)

Filename [MX1SEU_10Timer Recording.fm]
Masterpage:Left+
56
EN
TIMER RECORDING ON VHS DECK
Page 56Monday, 6 December 2004 14:01
Check, Cancel And Change Programmes
1
When the VHS recording lamp ( R) lights up on the unit
Press VHS j, then press DVD A.
When the VHS lamp does not light up on the unit
Press VHS so that the VHS lamp lights up on the unit.
2
Press PROGRAMME to access
the Programme screen.
3
Press F G to select
APROGRAMME/CONFIRMB,
then press ENTER to access the
Programme Check screen.
4
Press F G to select the
programme, then press ENTER.
The programme screen appears.
To cancel a programme
Press CANCEL.
5
Change the settings of the desired recording options as
required.
● Refer to steps 6 – 12 in AManual Timer ProgrammingB
(A pg. 55).
6
Press PROGRAMME to complete timer correction. The
previous screen resumes.
7
Press VHS j.
● The VHS recording lamp lights up on the unit and the HDD or
DVD deck is automatically selected. When the HDD or DVD
deck is in timer standby mode, the unit is automatically turned
off.
When Programmes Overlap Each Other
If APROGRAM OVERLAPPEDB appears, you have another
programme overlapping the programme you have just made.
The Programme Check screen appears and conflicting
programmes will start blinking.
Example: Programme 1 (you have just made) and Programme
4 overlap each other.
1
Confirm the overlapping programmes. Overlapping
programmes blink on the TV screen.
2
Press F G to select the programme to modify, then press
ENTER or E.
● You can only select one of the overlapping programmes.
NOTE:
If you do not mind this overlap, press PROGRAMME to finish the
timer programme setting. The programme with the lower
programme number will be recorded and the other one will not be
recorded correctly. If no changes are made for approximately 1
minute, the unit will return to the normal screen.
3
Press F G to select the desired programme to be cancelled or
changed.
To cancel the programme
Press CANCEL.
● APROGRAM COMPLETEDB appears on the TV screen for about
5 seconds, then the normal screen resumes.
To change the programme setting
Press ENTER, then go to step 4.
4
Change the programme setting.
● Refer to steps 6 – 12 in AManual Timer ProgrammingB
(A pg. 55).
5
Press PROGRAMME to access the Programme screen, then
press
F G to select APROGRAMME/CONFIRMB to check if the
conflict has been settled.
Programme check screen appears.
● APROGRAM COMPLETEDB appears on the TV screen for
about 5 seconds, then the normal screen resumes.
6
Press VHS j.
NOTE:
When any overlaps remain after deletion and modification of
programmes, Programme Check screen remains showing the
conflicting programmes. In such a case, repeat the procedure
above until the conflict is solved.
rtwe
PROGRAMME
ENTER
CANCEL
VHS
VHS#
1
CABLE/SAT
DVD TV
DATE START STOP
[ JK]N[ENTER]
[PROGRAMME] : EXIT
CH
CURSOR : [ HI] SELECT : [JK]
CONFIRM : [ENTER]
DATE START
DAILY/WEEKLY TV PROG
STOP
SP/LP
SP
ARD
VPS/PDC
OFF
MON-FRI
DATE START STOP
[ JK] N [ENTER]
[PROGRAMME] : EXIT
CH
DAILY
PROGRAM OVERLAPPED
MX1SEU_00.book Page 56 Monday, December 6, 2004 2:01 PM