Juniper Networks E-Series - Manual (Page 106)

CHAPTER 8
Accessing E-Series Routers 8-6
The system is now in Global Configuration mode, from which you
can configure the system. See
E-Series System Basics Configuration
Guide, Chapter 2, Command Line Interface .
Caution: Do not change the IP address for the Ethernet interface that you are
using to communicate with the system. If you change the address, you will lose the
Telnet session.
SNMP
The system supports Simple Network Management Protocol (SNMP), a
standard management protocol for IP networks. You can configure the
system as an SNMP agent.
As an SNMP agent, the system provides access to management
information that it maintains. See
E-Series System Basics Configuration
Guide, Chapter 3, Configuring SNMP for information on SNMP. See
E-Series Command Reference Guide A to M and E-Series Command
Reference Guide N to Z for the commands that are available for
configuring the system as an SNMP agent.
The Next Step
Turn to Chapter 9, Maintaining E-Series Routers .