Juniper Networks E-Series User Manual
Page 240
Index
4
managing 5-5
protocol support 13-1
removing 5-11
repairing and replacing 5-7
replacing 5-5
self-testing 10-3
storing 9-2
See also I/O modules; line modules; SRP
modules
monitoring LEDs 10-2
monitoring temperature 10-9
mounting a CD on an FTP server B-4, B-11, B-14
mounting kits 3-6
mounting posts for rack 3-6
N
setting up console 8-2 to 8-4
SNMP 1-15, 8-6
Telnet setup 8-4
NMC-RX Device Management System 1-16
notice icons defined xvi
NVS cards 1-13
installing 9-3 to 9-5
storing 9-2
O
OCx/STMx ATM modules, protocols 13-9
OCx/STMx modules, protocols 13-2
OCx/STMx POS modules, protocols 13-10
OK LED 10-3
ONLINE LED 10-3
order of module installation 5-6
P
packet classification 1-15
PCMCIA slot, SRP modules 1-13
performance rate, line modules 1-4
pinouts, E-series router cables and connectors A-1
planning site for installation 3-1
plenum 4-3
ports
alarm 6-5
console 6-5
external timing 6-5
power
cabling power input module 6-9, 6-10
consumption
SRP modules 12-15
system 11-2, 11-4, 11-6
dissipation 11-1, 11-3, 11-5
failures 10-2, 10-7
source A 10-3, 10-7
source B 10-3, 10-7
specifications 11-2, 11-4, 11-6
POWER A LED 10-3
POWER B LED 10-3
power cord warnings 3-4, 4-5
powering down E-series router 7-3
powering up E-series router 7-1
power input module, cabling 6-9, 6-10
power switches 6-10, 7-2
preinstallation responsibilities 3-1
preparing site for installation 3-1
Privileged Exec command mode B-4, B-9
problems. See troubleshooting
protocol support 13-1
Q
QoS, packet classification for 1-15
R
rack, distribution. See distribution rack
reaching an FTP server. See FTP access
rebooting. See booting
RED ALM LED 10-4
redundancy
redundancy features (hardware) 1-16
fans 1-19
line modules 5-13
ports 5-16, 6-20
SRP modules 1-16
redundancy status 10-9
REDUNDANT LED. See LEDs
release mechanisms for SFPs 9-9
release notes xix