Juniper Networks E-Series - Manual (Page 72)

CHAPTER 5
Installing Modules 5-12
Figure 5-6 Ejectors in the closed position
5 Carefully slide the module out of the chassis.
6 Place the module in its antistatic bag.
7
Cover the empty chassis slot with a blank faceplate, and tighten the
faceplate’s captive screws using a Phillips screwdriver. Turn both
screws several times before tightening them completely.
If you remove an I/O module and not the corresponding line module, the
line module reboots. Its status becomes “inactive” when you issue the
show version command.
If you remove a line module and do not delete the corresponding
configuration, the status of the line module will be “not present” when
you issue the
show version command.
Closed

Opened
Œ
Closed

Opened
Œ
g013747