Seiko Group BP-9000 - Manual (Page 39)

Setting top of form position
The top-of-form (TOF) can be set using this function, anywhere from a minimum of 0 inch to a
maximum of 480/60 inches (8 inches = 203mm) by increments of 1/60 inch.
Press the Up or Down arrow keys to increase or decrease the TOF setting, respectively. Press
the ENTER key to select the desired setting.
Note: Any improper setting of TOF position will set it back to the default value. The top of
form differs from the top margin in that the top of form determines the first line of the print
station where the top margin can be moved anywhere between the top of the form and the
bottom margin. See "40 TOP MARGIN" on page 47.
Loading user & factory setup options
Loads one of three user designed setup options to the current active memory. This will erase
and replace setup contents in the current memory. The printer has three setup storage areas that
can store different setups. If you need to save the current setups before replacement, it is
necessary to select the “86 SAVE SETUP” item in the extended setup options on page 56.
Note: When this setting is executed, the printer will be initialized.
8 SELECT SETUP
SETUP: MEMO 1
SETUP: MEMO 2
SETUP: MEMO 3
SET.: FACTORY
7 TOF ADJUST
TOF: + 0/60IN
TOF: +nnn/60IN
TOF: +480/60IN
Equivalent short cut operation can be performed when:
........... pressing the PARK key with the RESET key,
........... pressing the QUALITY key with the RESET key,
........... pressing the M.LF key with the RESET key.
........... Defaults to 14/60 inch
Note
When using settings less then 14/60", the printer is more susceptible to a paper jam,
depending on forms type being used.
31
4. Basic setup options (7-8)