Sony LF-X1 - Manual (Page 58)

F:\Joutou\#4090332_Sony_LF-X\4103221121up\4103221121\4103221121LF-
X1\00GB05C01-WW.fm masterpage: Left
LocationFreeTV
4-103-221-12(1)
58
For example, you can register monitor B
to base station A in following
procedures.
Setting up base station A:
• Select [Wireless] under [Home]. (Refer to
“Wireless Connection at Home” ( 1 page 47).)
• Select [Enable] for NetAV. (Refer to “Start up
the NetAV server on the base station”
(
1 page 56).)
• Set the base station to accept registration from
monitor B. Write down the password for
registration. (Refer to “Setting up for additional
monitors” on this page.)
Setting up monitor B:
• Select [Wired LAN] or [Wireless] under [On
the go]. (Refer to “Wired LAN Connection On
the Go” (
1 page 48) or “Wireless Connection
On the Go” ( 1 page 49).)
• Set IP address/domain name and port number
to connect to base station A. (Refer to
“Configuring the monitor to connect using
NetAV” (
1 page 57).)
• Enter registration password acquired from the
base station A setting, and select [Start] to
register. (Refer to “Registering other monitors
to the base station” (
1 page 59).)
Configuring base station settings
Configure settings so that additional monitors can
be registered to the base station, and so monitors
can access the base station with NetAV.
Perform these settings on the base station and
home monitor together.
Setting up for additional monitors
In this section, you can also set whether to allow
AV interception on a bound monitor.
1
Open the [Settings] window and select [Base
station].
The [Base station] window appears.
2
Select [NetAV Settings].
The [NetAV Settings] window appears.
Note
[NetAV Settings] can only be selected when the
monitor is set to Home-Wireless mode. If you
cannot select [NetAV Settings], check your
monitor settings.
3
Select [Register other monitors].
The [Register other monitors] window
appears.
4
Configure the following settings.
1 Select [Start].
2 Check this check box if you allow AV
interception by registered monitors.
z Tip
The monitors currently registered to the base
station are listed under [Registered monitors:]. To
delete a registered monitor, select the check box
beside the monitor, and then select [Delete].
An 8-digit password is created and appears
on the screen.
You should write this password down
because you will need it when connecting
another monitor to the base station.
5
Select [Back].
The [NetAV Settings] window reappears.