Sony LF-X1 - Manual (Page 59)

F:\Joutou\#4090332_Sony_LF-X\4103221121up\4103221121\4103221121LF-
X1\00GB05C01-WW.fm masterpage: Right
LocationFreeTV
4-103-221-12(1)
59
What’s NetAV
Setu
p an
d Co
nn
ecti
o
n
s
6
Select [Back].
The [Base station] window reappears.
7
Select [Settings], then select [Exit].
Configuring additional monitor
settings
Once the base station is set up to allow additional
monitors, set up the monitors to connect to the
base station via the Internet.
Perform these settings on monitors to be used
from outside the home.
Setting up to connect to the base station
via the Internet
Refer to “Setting Up NetAV” ( 1 page 56), and
set up to connect to the base station via the
Internet.
Note
If the IP address or domain name and port number for
the base station you want to register are not input
correctly, you cannot proceed with registration.
Registering other monitors to the base
station
Register the monitors that will connect to the base
station via the Internet.
Note
Switch the connection type for the monitor to [On the
go-Wireless] or [On the go-Wired LAN] depending on
the connection used for On the go to start NetAV.
1
Display the [Settings] window, and select
[Monitor].
The [Monitor] window appears.
2
Select [NetAV Settings].
The [NetAV Settings] window appears.
3
Select [Registration for Binding].
The [Registration for Binding] window
appears.
4
Configure the following settings and select
[Start].
1 Enter the [Password for registration] that
was created in step 4 of “Setting up for
additional monitors” (
1 page 58).
2 Enter the name of the monitor being
registered to the base station.
You can register any name.
3 [Start] button
A confirmation message appears.
5
Select [OK].
6
Select [Back].
The [Monitor] window reappears.
7
Select [Settings], then [Exit].
Continued