Connecting with netav – Sony LF-X1 User Manual
Page 60
F:\Joutou\#4090332_Sony_LF-X\4103221121up\4103221121\4103221121LF-
X1\00GB05C01-WW.fm
masterpage: Left
LocationFreeTV
4-103-221-12(1)
60
Notes on using NetAV with
additional monitors
Refer to the illustration in “Registering Other
Monitors” (
• Only one monitor can enjoy video with the base
station at once. In the case when the two
monitors B and C are registered to the base
station A, monitor B or C cannot establish a
NetAV session with the base station A while
the monitor A is receiving video from base
station A.
• If you have configured the base station A to
enable [Allow AV interception by registered
monitors] in the [Register other monitors]
setting, monitor B or C can start NetAV while
the monitor A is receiving video from the base
station A.
• When your monitor A cannot receive video
because monitor B or C is in a NetAV session
with the base station A, you can see the
indicator
at the top of the screen. If you
press [GetAV] button in such a case, the NetAV
session between monitor B or C and the base
station A will be disconnected and your
monitor A can receive video from the base
station A.
This chapter describes how to start NetAV and
some functions for NetAV. Follow the procedure
on page 49 to 51 to use NetAV in the “On the go-
Wireless mode”.
Note
You cannot use NetAV while away from home if the
base station in your home is turned off. Make sure to
turn on the base station.
When Connecting via Wired LAN
Using a LAN cable, connect the LAN port on the
monitor to the Ethernet jack at the place you are
visiting.
◆For the LF-X1
◆For the LF-X5
Connecting with
NetAV