Sierra Wireless EV-DO - Manual (Page 150)

PinPoint-E EV-DO
145 20070914
• n=0‐255 minutes
Note: There is always a minimum of 1 minute between power down
event and actual shutdown (to give the PinPoint-E time to prepare);
entering zero will not power down the modem immediately, but after
one minute.In the first 5 minutes after PinPoint-E powers up, power
down events are ignored to give the user time to change configura-
tions.
VLTG=n
Set or query the voltage level at which the PinPoint‐E goes into
low power mode.
• n=0 : Ignore voltage for power control.
• n=threshhold in tenths of volts
Example: ATVLTG=130 would place the modem in a low
power use, standby state if the voltage goes below 13.0V.
Friends
Friends Mode can limit access to the PinPoint‐E from the
cellular network and the Internet. Friends mode is a basic
firewall.
Caution: If you are using Friends Mode you will not be able to use
AceManager remotely or Telnet to the modem unless you are
contacting the modem from one of the configured IP addresses.
Note: Friends Mode will only prevent the PinPoint-E modem from
receiving data from those IP addresses not on the Friends List. It
cannot prevent data, such as pings, from traversing the network to the
modem which may billable traffic even though the modem does not
receive the data.