Sierra Wireless EV-DO - Manual (Page 97)

Global Positioning System (GPS)
Rev 3.0B Feb.08 92
Device ID
By enabling *PPDEVID, a device ID of the PinPoint‐E is sent as
part of the RAP message to make identification easier in a
network or fleet of vehicles equipped with PinPoint line
devices.
Figure 9-19: AceManager : PinPoint - *PPDEVID
With *PPDEVID enabled, the PinPoint‐E will use the value
configured for *NETPHONE for the device ID. If *NETPHONE
is empty, the ESN of the modem will be used.
Tip: If the PinPoint-E is using a dynamic IP, *PPDEVID needs to be
enabled.
Odometer Data in Reports
When the odometer report is enabled, the PinPoint‐E will
calculate distance between reports based on GPS data. The
modem’s odometer calculations can be included in the RAP
message.
Figure 9-20: AceManager : PinPoint - *PPODOM, *PPODOMVAL
• *PPODOM enables the odometer reporting.
• *PPODOMVAL is the current odometer reading in the
PinPoint‐E. You can set this to a number to offset the
odometer calculation, such as one‐time manual synchroni‐
zation of the PinPoint‐E odometer with the current vehicle
odometer.
Note: The odometer calculations of the PinPoint-E may not match the
odometer in the vehicle itself. The PinPoint-E odometer is not
connected to the vehicle’s, it is entirely based on calculations of GPS
readings.
Serial Input Event Reports
You can configure the PinPoint‐E to send reports to the AVL
Host based on the state of the digital inputs.